AIRMAGNET SITE SURVEY ACROSS BOTH BANDS SERIAL
AIRMAGNET SITE SURVEY ACROSS BOTH BANDS UPDATE

Once the AP has finished downloading the requisite code, it should reboot. If you’re using a different AP, ensure you’re using the proper image file name (ap1gx) for your upload here. Run the following command to convert your AP to eWC mode:įor the 9115/9120: ap-type mobility-express t tįor the 9117: ap-type mobility-express t t Attach your workstation to the Ethernet port on the VenVolt.

AIRMAGNET SITE SURVEY ACROSS BOTH BANDS UPDATE

Put the update files into your TFTP server directory. Statically assign an IP address to your workstation (192.168.1.3/24). Wait until you get to the AP prompt and configure the APs IP address to be on the same subnet as your workstation (192.168.1.2/24) using the following command: AP7069.5A76.5460#capwap ap ip 192.168.1.2 255.255.255.0 192.168.1.1

AIRMAGNET SITE SURVEY ACROSS BOTH BANDS SERIAL

Boot your AP with the serial cable attached. Both these code versions are available on .Īttach your AP to the VenVolt PoE out port. You MUST upgrade the CAPWAP image on the C9100 Access Points to AireOS 8.10.105.0 or IOS-XE 16.12.1s. Step 1) Assuming your AP is currently in CAPWAP mode, you will first need to update the AP with the proper CAPWAP image prior to flashing it with EWC code.

A serial console cable to watch/configure your APĪpplying the correct image to the platform:.802.11ax (Wi-Fi 6) Access Point (at the time of this writing, this is a c9115, 9117, c9120 or c9130 AP).TFTP server (this guide uses the TFTP server Transfer from Adrian Granados).Local power source for your Access Point (this guide uses the Ventev VenVolt site survey battery pack).If you have issues with APs joining, please make sure you’re using a production AP. This is unlikely to be an issue for most of you, but it should be noted that if you’re using a pre-production AP, it may not have the proper certificates required for this process. Production 802.11ax (Wi-Fi 6) Access Point.This is similar to 802.11ac wave 2 APs in that the WLC software runs on the AP after boot time, but the config model is notably different. Now that Cisco has launched the Embedded Wireless Controller (based on the CAT9800 platform), we can now use that functionality to do an APoS battery powered survey with a single AP! This is known as the Embedded Wireless Controller on Catalyst 9100 Access Points (or eWC for short). You may already be familiar with my Survey with Wi-Fi 6 APs workaround blog post previously where we used an AireOS WLC running on a second AP to do a site survey.

Airmagnet site survey across both bands